IGBT D
IMMER
R
ACKS
Installation
& Operation
25
A
TTACHING THE
D
OOR
When all wiring and testing is complete, attach the rack door. Do not operate the rack without the door in place.
1. Remove the two screws from the bottom of the rack (
Figure 21
).
2. Attach the bottom hinge to the rack using the screws removed in Step 1.
3. Insert the pin of the bottom hinge into the hole in the bottom of the door.
4. Remove two screws from the top of the rack.
5. Insert pin of top hinge into hole on top of door. Attach hinge to rack using screws removed in Step 4.
6. Close and open the door a few times to make sure it latches and unlatches easily. If it does not, loosen hinge screws and readjust.
Important
: Put the rack key in a safe place or turn over to owner.
M
AINTAINING
C
LEANLINESS
If the room will be subject to sheet rock dust or other debris, protect the rack with plastic wrap. Do not energize rack with plastic in
place. Failure to keep rack clean may affect proper operation and void warranty.
Finish and Test (continued)
Figure 21: Door Hinges
Top hinge
Bottom hinge
