UK
Inclination sensor JN
3
13.2 Analogue output as voltage source 2...10 V. . . . . . . . . . . . . . . . . . . . . . 24
13.3 Teach ASP and AEP via system commands . . . . . . . . . . . . . . . . . . . . . 25
13.4 Fault message on analogue outputs . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
14 Parameter setting of the digital switching outputs . . . . . . . . . . . . . . . . . . . . . 26
14.2 Output function "hysteresis (normally OFF; normally open)" [Hno] . . . . 30
14.3 Output function "hysteresis (normally ON; normally closed)" [Hnc] . . . . 30
14.4 Switching output "window (normally OFF; normally open)" [Fno] . . . . . 32
14.5 Switching output "window (normally ON; normally closed)" [Fnc] . . . . . 33
14.6 Set points SP and reset points rP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
14.6.1 Setting via ISDU indices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
14.7 Teach SP and rP via system commands . . . . . . . . . . . . . . . . . . . . . . . . 34
14.8 Switching delay dS1 / dS2 and switch-off delay dr1 / dr2 . . . . . . . . . . . 35
14.9 Logical operation of the switching outputs . . . . . . . . . . . . . . . . . . . . . . . 36
14.10 Function of the switching outputs in case of a fault FOU1 or FOU2 . . 37
14.11 Delay of the switching outputs in case of a fault (dFo) . . . . . . . . . . . . . 37
14.13 Restore the factory setting (system command 0x82). . . . . . . . . . . . . . 39
15 Status LED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
16 Maintenance, repair and disposal. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
17 Approvals/standards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
18 Factory setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
This document is the original instructions.