UK
Inclination sensor JN
17
The status of the teach point (set or deleted) can be read at any time via the ISDU
index 4104.
The result of this is that at the teach moment the xs axis must not be parallel to the direction of
gravitation. As long as the value for the ISDU index 4104 is 1, all angle indications are converted into
the new reference system.
The teach operation can, for example, be as follows:
The measured object with the non-aligned inclination sensor is brought into a
known horizontal position. In this position the teach function is carried out, thus
defining the new reference system. All provided angle values then refer to this new
reference system.
Even with an inclination sensor which is installed at an angle note that the x axis (x
s
axis) of the
sensor is parallel to the x
b
z
b
plane of the requested reference system.
Explanatory example
Inclination sensor installed at an angle in the
coordinate system of the workpiece. The coordinate
system of the sensor is transferred to the coordinate
system of the workpiece by teaching the inclination
sensor when the workpiece is horizontally aligned.
The raw data of the sensor is indicated in the
coordinate system of the sensor.
In teach mode the data is converted into the
coordinate system of the workpiece.
The example shows a rotation of 30° about the y axis of the coordinate system of
the workpiece.
Perpendicular angle
without teach
Teach mode
Perpendicular angle
without teach
Teach mode
Longitudinal
angle value
Lateral
angle value
Longitudinal
angle value
Lateral angle
value
Longitudinal
angle value
Lateral angle
value
Longitudinal
angle value
Lateral angle
value
-13.2°
-29.3°
0°
0°
-45.5°
-29.5°
-30°
0°