IEMCA VIP80E-II, Manual For Use And Maintenance

Page: 75 / 108

5 - ADJUSTMENTS AND SETUP VIP80E-II
EN
5 - Pag. 3 / 8
5.3 MAGAZINE ADJUSTMENT (HEXAGONAL BARS)
For using hexagonal bars, the following adjustments are necessary:
- mechanical adjustment of the magazine;
- setting the parameters using the push button panel.
Mechanical adjustment of the magazine
In order to machine hexagonal bars it is necessary to modify the magazine position. Adjust as
follows:
- Unscrew the screws which fasten the Teflon washers (D)
- Remove the Teflon washers (E)
- insert the lever (B) in the special holes in the hub (C);
- remove the screws (A);
- rotate the hub in order to modify the magazine position;
- Based on the type of bar to be machined, insert screws and Teflon washers in the special
slot:
higher in the case of machining hexagonal bars (steeper slope)
lower in the case of machining round or square bars (less steep slope)
- reassemble the screws (A).
INFORMATION:
At the end of this operation, the magazine will have a greater inclination. This is
essential to make the hexagonal bars slide along correctly.