IEMCA VIP80E-II, Manual For Use And Maintenance

Page: 27 / 108

2 - TECHNICAL INFORMATION VIP80E-II
EN
2 - Pag. 11 / 28
Example of bar feeder start in automatic mode (detection of C2 condition)
Press the key ,
if the lathe collet is open the display shows:
41 Close the collet!
To begin with Start-up procedure it is necessary to
receive a Start-up signal from lathe. If that does not
happen the display will show: "Waiting for Start-up
from lathe".
Operation only allowed to authorized
personnel.
In case the lathe does not manage the signal,
just set Start-up subparameter to 1 in
parameter 85.
INFORMATION:
The messages described above appear in
all four conditions from C1 to C4 depending
on the characteristics described for each
one.
41 Close the collet!
46 Waiting for start-up
from lathe
Start from lathe
0 (0=NO/1=NC)
Safeties from lathe
1 (0=NO/1=NC)
Door safety
0 (0=NO/1=NC)
Startup
1 (0=NO/1=NC)