IEMCA VIP80E-II, Manual For Use And Maintenance

Page: 102 / 108

EN
8 - TROUBLES - CAUSES - CURES VIP80E-II
8 - Pag. 2 / 4
8.1 GENERIC TROUBLESHOOTING
TROUBLES CAUSES SOLUTIONS
Blackout Check the electrical connection.
Guard open Close the guard.
Incorrect bar feeder programming
or magazine out of position
Disconnect the emergency devices.
Motor thermal switch tripped.
Reset the thermal circuit breaker
with the special buttons.
The bar feeder will not start
Lack of compressed air Check the pneumatic connection
The bar feeder has been reset
but the automatic cycle will
not start.
No lathe signal.
Check the electrical connection
with the lathe.
8.2 BAR MAGAZINE TROUBLESHOOTING
TROUBLES CAUSES SOLUTIONS
During loading the bar does
not enter into the lathe
correctly.
The loading axis is not correct.
Within parameter 80 adjust the
subparameter “Correction” in
Magazine adjustment. For further
information on the parameter
modification methods refer to the
“Instruction manual” attached.
The bars are not selected
correctly
If working with small bars, check
that they are not overlapping each
other
Check and remove any overlapping
bars (par. 6.6)
The hexagonal bars do not run
smoothly in the magazine
Incorrect bar feeder programming
or magazine out of position
Adjust the magazine position (par.
5.2) and check that the position of
the magazine is correct (par. 5.2)
The square bars do not run
smoothly in the magazine
Incorrect bar feeder programming
or kit for square bars not installed
Check that the set programme is
correct (par 5.3) and check that
the kit for square bars has been
installed correctly and that the TK
parameter has been modified (par.
5.3)
Difficulty introducing the bar
into the spindle line of the
lathe
Guide channel not centred with the
spindle line of the lathe
Set the value of the ø close to the
bar being used, in Parameter 8