6 - USE AND OPERATION
VIP80E-II
EN
6 - Pag. 9 / 14
For the loading proceed as follows.
- Using the push-button panel lift the bar selection
table;
- Open the rear guard (A);
- Extract the relative supports (B) in order to
facilitate loading the bars into the magazine;
- Load the bars into the magazine so that they are
resting on the rear surface (C) of the magazine.
INFORMATION:
When filling up the magazine with bars
that have reduced diameter dimensions,
take care to ensure that the bars are not
overlapping each other.
6.7
BAR FEEDER TOOLING
Before starting machining bars with features different from the previous ones, it is necessary to
tool the bar feeder proceeding as follows.
- If necessary, replace the bar pusher (see table on bar diameters and bar pusher paragraph
2.5 and paragraph 6.8 Bar pusher change).
- If necessary, replace the lathe spindle liners (see paragraph 6.9).
- Adjust the loading axis (see paragraph 4.6.1).
- Prepare the bars and load them on the magazine (see paragraph 6.5. and 6.6).
- Reset the work parameters (see "Instruction manual").
A
8070_06_07_1
B
B
C
Summary of Contents for VIP80E-II
