32
Mobil-O-Graph
®
, operating instructions, Rev. 5.1 10/2015, GmbH
4.
H
ypertension
M
anagement
S
oftware Client-Server
Read out measurements from 24-hour monitoring from Mobil-O-Graph
®
Starting situation:
■
Monitor is connected to the PC,
■
Mobil-O-Graph
®
is switched on,
■
PC is switched on,
■
Mobil-O-Graph
®
interface recognises HMS CS.
Step
Mobil-O-Graph
®
PC
1)
►
Start HMS CS.
If the program is set up for this, the window
Patient list will appear (see 4.12.7,
Extras
).
In this case, select a patient (see 4.6.2,
Selecting existing patient
)
►
In the toolbar, click
.
The question appears:
Assign measurements to
patient with ID number xxx?
►
Click
.
The question appears:
Delete patient ID and
measurements from the recorder?
►
Click
.
After data transmission the window
Measurement
series appears.
►
If necessary, change the times for the daytime
and night intervals.
►
Click
.
The transmitted measurements are displayed
as a Table of measurements.
2)
►
Switch off the Mobil-O-Graph
®
►
Disconnect cable (pull the plug from the data
port).
For further analysis of the measurement series see 4.11,
Analysing measurements.
4.7.2
Connection via Bluetooth
®
When using the Mobil-O-Graph
®
with a Bluetooth connection, follow these steps:
■
Configure monitor in HMS CS,
■
Set the monitor for the patient using HMS CS,
■
Test the monitor and put it on the patient.
After 24-hour monitoring
■
Take the monitor off the patient,
■
Read out measurements from the recorder and save them under patient information.
4.7.2