5 Terminals
3-12
KW2D Series Smart RFID Reader User’s Manual
5.1 Terminals for the Terminal Block
•
Choose an appropriate ferrule for the wire. For details, refer to "Wire Size and Recommended Ferrules" on page 3-
14.
•
Cut the wire carefully to get a flat end.
•
Make sure that ferrule sleeve is completely filled by the conductor. Depending on the cross section, the conductor
should protrude approx. 0 to 1 mm from the ferrule sleeve.
•
When crimping, refer to the instructions of the crimping tool.
•
Make sure that the finished size of the terminal after crimping is smaller than W2.1 x H1.48 mm. (Recommended
crimping tool, refer to "5.3 Recommended Tools" on page 3-15).
5
Terminals
•
If a tool other than the recommended crimping tool is used, the ferrule may not be crimped to the
appropriate size and the Power supply terminals may be deformed and may not operate normally.
•
Pin crimp terminals cannot be used.
0 to 1 mm
Max. 1.48mm
Max. 2.1mm
Caution
