2 How to install and remove
KW2D Series Smart RFID Reader User’s Manual
3-7
3
In
sta
lla
tio
n a
nd
W
irin
g
5
Align the TOP marks on the back unit and the front unit, and then insert the back unit into the front unit.
6
Confirm that the back unit is inserted fully into the front unit, and then while pressing the locking lever (1) on the
back unit, push it in the direction indicated by "LOCK
" (2).
This completes mounting the KW2D Series Smart RFID Reader to the panel.
You cannot insert the back unit into the front unit if the locking lever is in the lock position ("LOCk
").
Always confirm that the locking lever is in the unlocked position (opposite direction of "LOCK
").
•
Confirm that the locking lever is on the other side of the protrusion. The lock is not fully engaged if the
locking lever is not in the lock position ("LOCk
")
on the other side of the protrusion.
•
After attaching the back unit to the front unit, confirm that the back unit does not come off.
•
Tighten the locking ring to the specified tightening torque of 2.0
N·m.
•
The locking ring may break if needle-nose pliers or another tool are used to tighten the locking ring or the l
is tightened to more than the required torque. Use the locking ring wrench (Type No.: MW9Z-T1)
manufactured by IDEC.
•
After attaching the back unit to the front unit, confirm that the back unit does not come off.
The KW2D Series Smart RFID Reader can be mounted to metal panels (such as steel and aluminum) and resin
panels (such as plastic).
Front of back unit
TOP mark
TOP mark
Back of panel
Caution
(2)
Protrusion
(1)
Locking lever
Back of panel
Caution
Caution
