TUNNEL MASTER JR MANUAL
Operating Procedures
67
Shift Break
Introduction
There are two ways to break (close) a shift. The first is to go into Wash
Settings and select Yes for the Auto Shift menu option. This option will
automatically close the shift at midnight each night. The second option is
to go to the main display menu and select Shift Break. This option allows
the user to close a shift manually at a time selected by the user. This
option would be used by operators that wish to balance their shifts at the
end of the day instead of waiting until the next morning.
Helpful Tip
☺
It is very important that one of the two options be used each day. Failure
to close a shift will result in car and service counts being inaccurate, as
they would run multiple days into one shift. You may also you’re your
shift by pressing the up arrow on the entrance keypad.
DOING THIS
WILL RESET YOUR CURRENT CAR COUNT!
Procedures
Follow these procedures to manually break (close) the current shift.
Step Action
Screen
Displays
1
Access the Main Menu by
pressing the “Menu” button
on the display pad.
Note: If a password has been
set it will be necessary to
enter the password before
the main menu can be
accessed.
[1] Shift Break [4] View Counts
[2] Wet Down Wash [5] Print Reports
[3] Configure Wash
2
Press the numeric key “1” to
select
Shift Break
.
Note: A shift report will print
automatically at this point if
there is an optional report
printer attached.
Shift Break
Bump Shift (Y/N)?
3
Using the numeric keypad
press either “Y” for yes, or
“N” for no to close the shift
at this time.
Shift Break
Bump Shift (Y/N)? N
4
Press the [ENT] button on
the display pad to enter
selection and return to the
Main Menu
[1] Shift Break [4] View Counts
[2] Wet Down Wash [5] Print Reports
[3] Configure Wash