TUNNEL MASTER JR MANUAL
Wash Configuration
46
Type
Use the “0” button to advance to select the option desired.
M
= Mandatory, relay will activate for any service sold
that is set as a Base.
S
= Selective, relay will activate only when a service set as
an Extra Service is sold along with a Base service.
D
= Deselective, relay will NOT activate when a service
with this output is selected.
C
= Conveyor, relay is activating the motor starter solenoid
for the conveyor motor when a Panic circuit is wired to the
designated relay.
R
= Roller, relay activates the roller up solenoid. Start
time entered on Roller output will be how long the roller
up cylinder is activated. If you enter an extend time, the
system will fire the roller up relay for the start time, then
pause for the extend time and then fire for the start time a
second time. This is known as an up down up.
A
= Auto Stop, relay is tied to a stop circuit for shutting
down the car wash after the last vehicle exits the wash or
there is no wash activity. In order for this to work, you
must set the Auto Stop Period in the Wash Settings.
O =
This output is used to start the conveyor once you
have a base service selected.
NOTE: YOU MUST
HAVE A HORN RELAY SETUP WITH A START
TIME IN ORDER FOR THIS RELAY TO FIRE.
H =
This output will fire your Horn. The start time for this
output is how long, in seconds, that the horn will blow for.
The extend time is how long, in seconds, the system will
delay starting the conveyor.