TUNNEL MASTER JR MANUAL
Wash Configuration
47
Outputs
Menu Items
Function
Continuation of a list of menu items within the Outputs menu and a brief
explanation of their function.
Menu Item
Function
Part
Use the “0” button to advance to the desired choice for
what part of the car this piece of equipment is to turn on
for.
AC
= All of the Car
FH
= Front Half of the vehicle
FB
= Front Bumper only
RH
= Rear Half of vehicle
RB
= Rear Bumper only
TA
= Activate from a tire switch for tires or wheels. On A
Tire Output, The Start Time Is Where In The Tunnel The
Equipment Is And The Extend Time Is How Long The
Output Will Stay On For.
ES
= Entrance sign, relay will activate after vehicle is
“Loaded” and shut off as vehicle reaches gate switch. An
entrance sign can only be a Selective output. An Entrance
Sign may not be a Mandatory service.
EM =
Entrance Management relay will activate after
second tire hits the entrance management treadle which is
wired into Input 10. This relay will stay activated until
Min Car Length is reached.
Flash Enter
Y
for yes, or
N
for no if the relay is to flash on and
off when it is activated.
Extend
Enter the number of pulses or inches, depending on the
setup choice in Wash Settings, for how far past the actual
length of the vehicle the piece of equipment should stay
on.
Note: Many outputs must be turned on early in order to be
“charged” up before the vehicle gets to it. The Extend
feature allows the user to keep the relay activated so that
the rear of the vehicle does not get missed.
Look
Enter the number of pulses or inches for the system to look
back into the wash to see if there is another vehicle
approaching. If there is another vehicle within the setting
entered the system will leave that relay on to prevent
frequent stopping and starting of electric motors which
drives up utility charges.