Manual Number: 40110-005-2
Page 90
Code
Description
82
Keyboard controller interface test completed. Writing command byte and initializing
circular buffer next.
83
Command byte written, global data initialization completed. Checking for locked
key next.
84
Locked key checking over. Checking for memory size mismatch with CMOS RAM
data next.
85
Memory size check done. Displaying soft error and checking for pass- word or
bypassing Setup next.
86
Password checked. Performing any required programming before Setup next.
87
Programming before Setup complete. Uncompressing Setup code and executing
Setup utility next.
88
Returned from Setup program and screen is cleared. Performing any necessary
programming after Setup next.
89
Programming after Setup complete. Displaying power-on screen message next.
8B
First screen message displayed. “Wait...” message displayed. Performing PS/2
mouse check and extended BIOS data area allocation check next.
8C
Programming Setup options next.
8D
Setup options are programmed. Resetting hard disk controller next.
8F
Hard disk controller reset done. Configuring floppy drive controller next.
91
Floppy drive controller configured. Configuring hard disk drive controller next.
95
Initializing bus option ROM’s from C800 next. (See end of Port 80H Codes for
details of different buses.)
96
Initializing before passing control to adapter ROM at C800.
97
Initialization before C800 adapter ROM gains control completed. Adapter ROM
check next.
98
Adapter ROM had control and has returned control to BIOS POST. Performing any
required processing after option ROM returned control.
99
Any initialization required after option ROM test has completed. Configuring timer
data area and printer base address next.
9A
Set timer and printer base addresses. Setting RS-232 base address next.
9B
Returned after setting RS-232 base address. Performing any required initialization
before coprocessor test next.
9C
Required initialization before coprocessor test is over. Initializing coprocessor
next.
9D
Coprocessor initialized. Performing any required initialization after coprocessor
test next.
9E
Initialization after coprocessor test is complete. Checking extended key board,
keyboard ID and Num Lock key next. Issuing keyboard ID command next.
A2
Displaying any soft errors next.
A3
Soft error display complete. Setting keyboard typematic rate next.
A4
Keyboard typematic rate set. Programming memory wait states next.
A5
Memory wait state programming over. Clearing screen and enabling parity and
NMI next.
A7
NMI and parity enabled. Performing any initialization required before passing
control to adapter ROM at E000H next.
Summary of Contents for SB686P Series
