78
SCANS
1
2
3
4
5
6
7
9
10
12
13
14
15
16
17
18
19
20
21
11
8
8
A programmed scan searches for signals between
Program Scan Edge channels “P1” and “P2.”
Before starting the programmed scan, scan edges
must be programmed into these channels.
Refer to “
■
Memory Channel programming” to pro-
gram Program Scan Edge channels. (p. 70)
If the same frequencies are programmed into the
Program Scan Edge channels, the programmed
scan will not start.
q
Push [VFO/MEMO] to select the VFO mode.
w
Push a mode switch to select the desired operating
mode (p. ).
• The operating mode can also be changed while scan
-
ning.
e
Push [TS] one or more times to select a tuning step.
(p. 27)
• The tuning step can also be changed while scanning.
r
Push [MENU] once or twice to display the “M2”
screen (Menu 2).
t
Push [SCAN](F-1) to display the “SCAN” screen.
y
Rotate the [RF/SQL] control to set the squelch to
open or closed.
• The scan performance differs, depending on the squelch
setting when the scan was started. See page 76 for de-
tails.
• If the [RF/SQL] control function is set to “AUTO,” the
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
u
Push [PRO](F-1) to start or cancel the programmed
scan.
• The MHz and kHz decimal points, and “PROG SCAN”
blink while scanning.
• Rotating [DIAL] also cancels the scan.
■
Programmed scan/Fine programmed scan (VFO mode)
D
About the Fine programmed scan
When a signal is received during Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q
Start the programmed scan.
• Follow steps
q
through
u
as described above.
w
While scanning, push [FIN](F-3) to switch the scan
function between a programmed scan and a Fine
programmed scan.
• “F-PROG SCAN” blinks while Fine programmed scan
-
ning.
e
Push [PRO](F-1) to cancel the scan.
• Rotating [DIAL] also cancels the scan.
[SCAN]/[PRO]
[VFO/MEMO] [TS]
[MENU]
[RF/SQL]
Mode switches
While Programmed scanning
P R O
∂
F
SPAN
S E T
F I N
SCAN
∂
F
:
±
1 0 k
P R O
∂
F
SPAN
S E T
F I N
SCAN
PROG SCAN
P R O
∂
F
SPAN
S E T
F I N
SCAN
PROG SCAN
P R O
∂
F
SPAN
S E T
F I N
SCAN
F−PROG SCAN
While Fine programmed scanning
