3-6-2
Remote Control Operation
1
11
1----2 REMOTE CONTROL OPERATION
2 REMOTE CONTROL OPERATION
2 REMOTE CONTROL OPERATION
2 REMOTE CONTROL OPERATION
System control command
System control command
System control command
System control command
▒ NOTE
NOTE
NOTE
NOTE: All commands must be entered within 10 sec. of entering a password. It is possible to enter the password
▒ and command continuously.
Format of Command
Format of Command
Format of Command
Format of Command
• Basic command code
• Basic command code
• Basic command code
• Basic command code
The Basic command code consists of a fixed 4-digit command code, preceded by a 1-digit Header Tone, and
followed by a 1-digit De-limiter Tone.
Header Tone
Header Tone
Header Tone
Header Tone
The Header tone is sent ahead of the command and indicates the start of the command. This tone is a fixed 1-
digit from 0—9, A—D,
∗
(E), #(F) (programmed using CS-FR3000). The default setting is
∗
(E).
De
De
De
De----limiter Tone
limiter Tone
limiter Tone
limiter Tone
The De-limiter is sent between commands and at the end of remote control codes. This tone indicates a space
between segments of the command as well as the end of the command. This tone is a fixed 1-digit from 0—9, A—
D,
∗
(E), #(F) (programmed using CS-FR3000). The default setting is #(F).
Command Code
Command Code
Command Code
Command Code
This field indicates the pre-programmed command or action to be executed. These codes are programmed to fixed
∗
35
Sub Code
Sub Code
Sub Code
Sub Code
This field is entered following the command code and indicates a memory channel number (for Memory CH
Select), an Autodial number (for Telephone Autodial), or a telephone number (for manual Tel dial commands). The
Sub Code will be a fixed 2-digit code for Memory CH Select and Telephone Autodial commands or may be up to
24-digits for Tel dial command.
• Command with password and sub code continuously
• Command with password and sub code continuously
• Command with password and sub code continuously
• Command with password and sub code continuously
This is the format required for entering commands for remote control operation.
This field indicates the pre-programmed command or action to be executed. These codes are programmed to fixed
4-digit codes in cloning software, and may include characters from 0—9, A—D,
∗
(E), #(F).
• Command code with sub code
• Command code with sub code
• Command code with sub code
• Command code with sub code
The Command code with Sub code consists of basic command code and sub code (additionally required
information).
Password
Password
Password
Password
The Password is a type of command code. The FR3000/FR4000 will enter the “System Control standby mode”
when it receives this command while in normal operating mode. This is a fixed 4-digit code that is programmed
using cloning software and may include digits from 0—9, A—D,
∗
(E), #(F).
