Operation Example
RF Power (High)
RF Power (High)
RF Power (High)
RF Power (High) (
0008 Default)
This command is available from both the transceiver
both the transceiver
both the transceiver
both the transceiver
and phone line.
and phone line.
and phone line.
and phone line. This explanation shows the operation
from the transceiver when entering the password
and command continuously or step by step operation
from the phone line (one after the other).
This command cannot be performed while repeater is
transmitting, therefore you must stop the repeater
operation before changing RF power.
[From the transceiver]
[From the transceiver]
[From the transceiver]
[From the transceiver]
①
Enter the following DTMF code from the transceiver.
Code:
∗
0001#0004#
• Verify the repeater replies “OK ACK (3333).”
• If the repeater replies “NG ACK (4040),” make
sure the password, header tone, de-limiter tone
and Repeat Stop code are correct, and try again.
②
Enter the “RF Power (High)” command within 10 sec.
Code:
∗
0008#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0008#).
• The repeater changes transmit power Low to High.
③
Enter the “Repeat Start” command within 10 sec.
∗
[From the Phone line]
[From the Phone line]
[From the Phone line]
[From the Phone line]
①
Dial the phone number of the phone line that the
repeater is connected to.
②
When the connection has been confirmed, enter the
programmed password.
Code:
∗
0001#
• Verify the repeater replies “System Password OK
ACK (1111).”
• If the repeater replies “NG ACK (4040),” make
sure the password, header tone and de-limiter tone
are correct, and try again.
③
Enter the “Repeat Stop” command within 10 sec.
Code:
∗
0004#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
∗
40
∗
③
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0003#).
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0004#).
④
Enter the “RF Power (High)” command within 10 sec.
Code:
∗
0008#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0008#).
• The repeater changes transmit power Low to High.
⑤
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0003#).
⑥
Hang up the phone, the repeater automatically
disconnects the phone.
