Operation Example
CPU All Reset
CPU All Reset
CPU All Reset
CPU All Reset (
0018 Default)
This command is available from the phone line
the phone line
the phone line
the phone line
only.
only.
only.
only. This explanation shows entering the password
and command continuously.
This command cannot be performed while repeater
is transmitting, therefore you must stop the repeater
operation before performing CPU All Reset.
①
Dial the phone number of the phone line that the
repeater is connected to.
②
When the connection has been confirmed, enter the
following DTMF code.
Code:
∗
0001#0004#
• Verify the repeater replies “OK ACK (3333).”
• If the repeater replies “NG ACK (4040),” make
sure the password, header tone, de-limiter tone
and Repeat Stop code are correct, and try again.
③
Enter the “CPU All Reset” command within 10 sec.
Code:
∗
0018#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0018#).
• The repeater performs CPU All Reset.
④
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
44
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter
the password and command continuously (Code:
∗
0001#0003#).
⑤
Hang up the phone, the repeater automatically
disconnects the phone.
