3-3
Operation
Turning power ON
Turning power ON
Turning power ON
Turning power ON
①
Push [POWER] to turn power ON.
②
If the repeater is programmed for a power on
password by an Icom Dealer, input digit codes
directly.
• The keys in the table below can be used for
password input.
• The repeater detects numbers in the same block
as identical. Therefore “01234” and “56789” are
the same.
③
When the “PASSWORD” indication does not clear
after inputting 4 digits, the input code number may
be incorrect. Turn power off and start over in this
case.
Receiving and transmitting
Receiving and transmitting
Receiving and transmitting
Receiving and transmitting
Receiving
Receiving
Receiving
Receiving
①
Push [POWER] to turn power ON.
②
Set the audio and squelch levels.
31
②
Set the audio and squelch levels.
➥
Rotate [SQUELCH] fully counterclockwise in
advance.
➥
Rotate [VOLUME] to adjust the audio output level.
➥
Rotate [SQUELCH] clockwise until the noise
disappears.
③
Push [UP] or [DN] to select the desired channel.
•When receiving a signal, BUSY indicator turns ON
and audio is emitted from the speaker.
•Further adjustment of [VOLUME] to a comfortable
listening level may be necessary at this point.
Transmitting
Transmitting
Transmitting
Transmitting
①
Take the microphone off hook.
②
Wait for the channel to become clear.
③
Push and hold [PTT] to transmit, then speak into
the microphone at your normal voice level.
④
Release [PTT] to receive.
IMPORTANT:
IMPORTANT:
IMPORTANT:
IMPORTANT:
To maximize the readability of the transmitted signal:
(1) Pause briefly after pushing [PTT].
(2) Hold the microphone 1 to 2 inch (2.5 to 5 cm) from
your mouth, then speak into the microphone at a
normal voice level.
