![background image](http://html.mh-extra.com/html/icom/ic-7700/ic-7700_instruction-manual_612325181.webp)
12-19
12
SET MODE
Keyboard Repeat Delay
250ms
Sets the time period for delay from 100 to 1000 mil-
liseconds in 50 millisecond steps. (default: 250 mil-
liseconds)
When a key of the connected keyboard is held down
for the set period, the character is input continuously.
Keyboard Repeat Rate
10.9cps
Sets the repeating rate for the connected keyboard
within 2.0 to 30.0 cps. (default: 10.9 cps)
*cps=character per second
When a key of the connected keyboard is held down,
the character is repeatedly input with the set speed.
• Available repeating rate
2.0, 2.1, 2.3, 2.5, 2.7, 3.0, 3.3, 3.7, 4.0, 4.3, 4.6, 5.0,
5.5, 6.0, 6.7, 7.5, 8.0, 8.6, 9.2, 10.0, 10.9, 12.0,
13.3, 15.0, 16.0, 17.1, 18.5, 20.0, 21.8, 24.0, 26.7,
30.0
IP Address (Valid after Reboot)
192
. 168. 0. 10
Sets IP address for the IC-7700 when connecting to
your PC or LAN (Local Area Network) through the
Ethernet connector.
Turn the transceiver power OFF then ON to make
the setting effective. See page 16-7 for details.
Subnet Mask (Valid after Reboot)
255. 255. 255. 0 (24bit)
Sets subnet mask for the IC-7700 when connecting
to your PC or LAN (Local Area Network) through the
Ethernet connector.
Turn the transceiver power OFF then ON to make
the setting effective. See page 16-7 for details.
Default Gateway (Valid after Reboot)
.
. .
Sets the default gateway of the router that you want
to connect the IC-7700 to.
Only when you configure the remote control sys-
tem using an optional RS-BA1 through the Inter-
net, you need this setting.
Turn the transceiver power OFF then ON to make
the setting effective.
Network Control (Valid after Reboot)
OFF
Selects the remote control capability ON or OFF.
(default : OFF)
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this set-
ting.
Turn the transceiver power OFF then ON to make
the setting effective.
Control Port (UDP) (Valid after Reboot)
50001
Sets the Control port of the IC-7700 by accessing
from the remote station.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this set-
ting.
Turn the transceiver power OFF then ON to make
the setting effective.
■
Other set mode
(continued)