IBM xSeries 235, Maintenance & Troubleshooting

Page: 100 / 214

of the option.
2
1
Cables
Hot-swap power
supply option
a. Push the cables on the back of the power-supply option into the
power-supply bay first; then, slide the hot-swap power-supply cage with
power supplies into the power-supply bay.
b. From inside the server, pull the cables on the back of the power-supply
cage up from under the system board.
c. Secure the hot-swap power-supply cage to the server by installing the two
screws at each side of the hot-swap power-supply cage.
7. Connect the power-supply cables to the system board and devices in your
server.
Note: Each connector on these cables is unique. Only one type of cable can
be attached to each connector on the system board, backplanes, or
devices.
a. Connect the small-device power cable (P7) to the back of the diskette
drive.
Note: You might need to remove the diskette drive from the server in order
to disconnect and reconnect its cables. The diskette drive is held in
the server by release tabs that are accessed by removing the server
front bezel.
b. Connect the P4 device power connector to the back of the CD-ROM drive.
c. Connect the other device power connectors (P5 and P6) to the rear of any
other devices in the server.
d. Connect the SCSI cable (P2) to the SCSI backplane.
e. Connect the power cable (P1) to the J4 connector on the system board.
f. Connect the power signal cable (P3) to the J10 connector on the system
board.
90
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide