IBM ServeRAID-4 Ultra160 Series, User Reference

Page: 172 / 208

10. Using the settings that were assigned to the previous ServeRAID controller
(that is, the controller you are replacing), fill in each of the following fields:
v
SCSI initiator IDs
v
Controller name
v
Partner name
11. Click OK. The new controller stripe-unit size setting defaults to 8 KB. If you
need to change this setting to match the partner controller, go to step 12.
Otherwise, go to step 15.
12. In the Main Tree, click the new controller.
13. Click Actions
→
Change stripe-unit size.
14. Click the new stripe-unit size for your installation.
15. Shut down and turn off the server.
16. Reconnect the SCSI channel cables to the controller.
Note: Be sure to connect the cables to the correct SCSI channels as noted in
step 2 on page 153.
17. If the ServeRAID controller being replaced attaches to any of the following:
v
The server startup disk array
v
Other non-shared disk arrays,
start the system with the IBM ServeRAID Support CD (version 4.0, or later) in
the CD-ROM drive. The ServeRAID Manager program starts.
If the ServeRAID controller being replaced does not attach to any of these
items, go to step 21.
18. In the Main Tree, click the new controller.
19. Click Actions
→
Copy configuration from drives.
20. Click the merge group number for the non-shared logical drives (that is, 206 or
207).
Note: The last number in the merge group number is the shared SCSI initiator
ID. That is, if the merge group number is 206, the SCSI initiator ID is 6.
21. Remove the IBM ServeRAID Support CD from the CD-ROM drive.
22. Restart your server.
Note: If the controller you replaced is the startup controller, the system will
now start the operating system properly.
Figure 35. Configure controller for clustering window
154
IBM
®
User’s Reference: ServeRAID
™
-4 Ultra160 SCSI Controller