6. Line up the adapter with the expansion slot. Carefully
press the adapter into the slot until it seats firmly.
7. Secure the adapter in place.
8. Connect one end of the fiber cable from the devices
to the J1 connector on the adapter.
9. Carefully reinstall the computer cover and secure it.
10. Connect the power cables.
11. Power-on all external FC devices; then, power-on the
PC and observe the monitor. The BIOS lists all FC
devices attached to the PCI adapter,
QLogic Corporation
QLA21xx PCI Fibre Channel ROM BIOS Version X.XX
Copyright (C) QLogic Corporation 1998 All rights
reserved.
Press <Alt-Q> for Fast!UTIL
ISP21ðð Firmware Version X.XX
QLogic adapter using IRQ number X
Note
If there is not a hard-disk drive attached to the
computer, a read-only memory basic input/output
system (ROM BIOS) NOT INSTALLED message
displays after the device listing.
All installed devices should be listed on the monitor.
See the
Netfinity Fibre Channel PCI Adapter Software
Installation Guide for detailed instructions on how to install
the device drivers.
If the information displayed is not correct and you have
checked the adapter configuration, go to “General
Checkout” on page 21.
Device
Number
Device
Type
Adapter
Number
Loop
ID
Loop
LUN
Vendor
ID
Product
ID
Product
Revision
81
Disk
0
0
0
SEAGATE ST32550
7394
Fibre Channel Adapter (FRU 01K7354)
29
Summary of Contents for Netfinity Series
