![background image](http://html2.mh-extra.com/html/ibm/netfinity-series/netfinity-series_hardware-maintenance-manual_3998349038.webp)
Locations
This section contains the following:
“Adapter Layouts.”
Adapter Layouts
The following figure identifies the adapter components
referenced throughout this chapter.
J1
ISP2100
Installation Procedures
Note
To avoid damage to the fiber optic cables, follow these
guidelines:
Do not route the cable along a folding cable
management arm.
When attaching to a device on slides, leave
enough slack in the cable so that it does not
bend to a radius smaller than 3 inches when
extended or become pinched when retracted.
Route the cable away from places where it can
be snagged by other devices in the rack.
Do not over tighten the cable ties or bend the
cables to a radius smaller than 3 inches.
Do not put excess weight on the cable at the
connection point and be sure it is well supported.
Follow these steps to install the Netfinity Fibre Channel
PCI Adapter. Also refer to these steps for removal and
replacement.
1. Check the system board and make any configuration
changes necessary to accommodate the Netfinity
Fibre Channel PCI Adapter if the system requires it.
2. Power-off the peripheral devices, then the computer.
3. Disconnect the power cords.
4. Remove the computer cover, saving the screws.
5. The adapter can be installed in any PCI bus slot that
supports 32 or 64-bit adapters.
28
IBM Netfinity Fibre Channel HMM
Summary of Contents for Netfinity Series
