IBM InfoPrint 6700 Series, User Manual

Page: 113 / 384

Loading A Saved Configuration
113
QUICK SETUP
QUICK SETUP
Validator Funct.
7
Notes:
* = Factory Default
1
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User
is enabled.
3
Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer model (see Appendix A, “Specifications”).
5
Maximum value depends on model width and size of DRAM installed (see Appendix A, “Specifications”).
6
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 144. If you change
the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
7
Appears only if a validator is installed.
Print Intensity
6 ips* 1-10 ips
1
Print Speed
Paper Feed Shift
Label Width
Label Length
Orientation
4.1, 6.6, or 8.5 inches*
2, 4
Portrait* Landscape Inv. Portrait Inv. Landscape
-3* -15 to 15
00.1 to 8.5 inches
4
0.00 inches*
2
4 or 6 inches*
2, 4
00.1 to 99.0 inches
5
-0.50 to X inches
3
Run Calibrate
Auto Calibrate
Ver Image Shift
Hor Image Shift
0.00 inches*
2
-1.00 to 1.00 inches 0.00 inches*
2
-1.00 to X inches
3
Enable* Disable
Tear-Off Strip* Tear-Off Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
6
Disable* Mark Gap Advanced Notch Advanced Gap
Active IGP Emul
IGP/PGL* PPI/IGL PPI/TGL PPI/IGL IGP/VGL PPI/STGL
Transfer* Direct
Print Mode
Continued at the top of next page
QUICK SETUP