IBM Infoprint 1130, Service Manual

Page: 196 / 433

Diagnostic Aids
3-31
IBM Infoprint 1130/1140
Maintenance Page Count
This counter is reset by the servicer after a “80 Scheduled
Maintenance” message displays (300K copies) and a maintenance
kit is installed.
To view the Maintenance Page Count:
1. Enter the Configuration menu. Turn the machine off, press and
hold the Return and Select buttons. Turn the machine on and
wait until Performing Self Test is displayed before releasing the
buttons.
2. The Configuration Menu will be displayed.
3. Select Maintenance Page Count value from the menu.
4. Press Return to go to the previous menu.
To reset the Maintenance Page Count to zero:
1. Select Reset Maintenance Count from the Configuration menu.
•
The following is displayed:
Reset Maintenance Count
=Reset
2. To reset the Maintenance Count, press Select for =Reset.
Selecting =Reset causes the maintenance page counter to
reset to zero.
3. When the operation is complete, the menu returns to the Reset
Maintenance Count screen in the Configuration menu.
Setting Configuration ID
The configuration ID is used to communicate information about
certain areas of the printer that cannot be determined using
hardware sensors. The Configuration ID is originally set at the
factory when the printer is manufactured, however it requires
resetting whenever you replace the system board and can be set on
the operator panel. However the Configuration ID is the only
diagnostic function displayed until a valid ID is entered.
To set the Configuration ID:
1. Enter the Diagnostic mode.
2. Select Configuration ID from the Printer Setup menu.