IBM Infoprint 1130, Service Manual

Page: 186 / 433

Diagnostic Aids
3-21
IBM Infoprint 1130/1140
Twelfth Sheet: Bin #10, then the order reverses from Bin #9 to
the Standard Bin.
4. The test is continuous until either the Return or Stop button is
pressed.
Output Bin Feed Test
Note: If the “Configure Bins” printer setting is link rather than
mailbox, the printer selects its own internal bin linking regardless of
which output bin is selected for the feed test
This test is used to verify that media can be fed to a specific output
bin. No information is printed on the media fed to the output bin
because the printhead is not turned on during this test. This test can
be run from any input source and will support any size paper or
envelope supported by the printer.
To run the Output Bin Feed Test:
1. Select Feed Test from the Output Bin Test menu.
2. Select the output bin you want the paper to exit into. The
standard bin as well as any output option bin installed on the
printer is shown on the menu. (The output bin displayed is in the
order installed on the printer.)
3. Select either Single (one sheet of media feeds to the selected
output bin) or Continuous (media continues feeding to the
selected output bin) until Return/Stop is pressed.
4. Press Return/Stop to exit the test.
Output Bin Sensor Test
This test is used to determine whether or not the output bin sensor is
working correctly for the Standard Bin or the sensors are working for
the Output Expander, High Capacity Output Stacker, 5 Bin Mailbox
or StapleSmart Finisher Options if installed.
To run the Output Bin Sensor Test for: