IBM EXP15, Hardware Maintenance Manual

Page: 61 / 146

5. Tighten the two front screws
2
; then, tighten the
four large screws
3
.
Repeat step 2 on page 52 through step 5 to install
the rail marked "R" on the right side of the rack.
6. Slide the expansion unit into the rack; then, remove
and discard both white screws and wingnuts
1
from
the bezel.
7. Align the bezel locator pins with the expansion unit;
then, secure the bezel and EXP200 with two black
hex screws
2
.
8. Use the two small screws
3
(removed in step 2 on
page 52) to secure the rear of the expansion unit.
9. Verify that Option Switch 5 is set to Off (see “Setting
the interface options” on page 48 for further device
settings).
10. Install hard drives, fans, and power supplies in the
EXP200 expansion unit
Netfinity EXP200 Type 3530
53