IBM EXP15, Hardware Maintenance Manual

Page: 64 / 146

4. Hold the rail against the outside of the left enclosure
mounting flange and loosely insert the front black hex
screws
4
.
5. Extend the rail outside of the rear enclosure mounting
flange; then, install and tighten both rear black hex
screws
5
.
6. Tighten the two front screws
4
; then, tighten the
four large screws
3
.
Repeat step 3 on page 55 through step 6 to install
the rail marked "R" on the right side of the enclosure.
7. Slide the expansion unit into the enclosure; then,
remove and discard both white screws and wingnuts
6
from the bezel.
8. Align the bezel locator pins with the expansion unit;
then, secure the bezel and EXP200 with two black
hex screws
7
.
9. Use the two small screws
2
(removed in step 3 on
page 55) to secure the rear of the expansion unit.
10. Install hard drives, fans, and power supplies in the
EXP200 expansion unit.
56
IBM Netfinity EXP15, EXP200, EXP500 HMM