Preparing the expansion unit:
The following
information explains how to prepare the expansion unit for
installation by removing the CRUs (customer replaceable
units) and by setting the interface options.
Removing CRUs:
It is easier to lift the expansion unit
and install it in a rack if you remove all CRUs (drives, fans,
power supplies, and ESM cards) first. A fully loaded
expansion unit with 10 disk drives, two fan units, two ESM
boards, and the two power supplies installed weighs 35.5
kg (78 lbs). If you remove all the CRUs, you can reduce
the overall weight.
Attention
If you have data stored on the drives, label the drives
before you remove them. Then when you replace the
drives, install them in the same drive bays from which
you removed them. Otherwise, you you might lose
data.
See “Installing and replacing devices” on page 83 for the
information needed to remove the CRUs.
Caution
Use safe practices when lifting.
Attention
The expansion unit is shipped with the decorative
bezel attached to the front of the unit with two white
screws and nuts. This bezel protects the light pipes
located above the drive trays. Leave the decorative
bezel in place until you are instructed to remove it
during the installation process.
36.1 kg (79.5 lbs)
Netfinity FAStT EXP500 - Type 3560
75
Summary of Contents for EXP15
