IBM EXP15, Hardware Maintenance Manual

Page: 97 / 146

.
e. Verify that there is proper identification (such as
a label) on the drive CRU, then slide it
completely out of the expansion unit.
f. If you are replacing a slim-line drive, ensure that
the filler piece remains in place for use with the
new drive.
3. Install the new drive CRU.
a. Gently push the drive CRU into the empty bay
until the tray handle
2
touches the expansion
unit bezel.
b. Push the tray handle
2
down into the closed
(latched) position.
4. Check the drive LEDs.
a. When a drive is ready for use, the green Activity
LED is on and the amber Fault LED is off.
b. If the amber Fault LED is completely on and not
flashing, remove the drive from the unit and wait
10 seconds; then, reinstall the drive.
5. Return to normal operation.
Working with hot-swap power supplies:
The
power supplies are customer replaceable units (CRUs) and
do not require preventive maintenance.
The power supplies must always be in their proper
places to maintain proper expansion-unit cooling.
Use only the supported power supplies for your
specific expansion unit.
Removing a hot-swap power supply:
Netfinity FAStT EXP500 - Type 3560
89