![background image](http://html1.mh-extra.com/html/ibm/exp15/exp15_hardware-maintenance-manual_3992345099.webp)
To install a hot-swap power supply:
Caution
Never remove the cover on a power supply or any
part that has the following label attached.
Hazardous voltage, current, and energy levels are
present inside any component that has this label
attached. There are no serviceable parts inside these
components.
1. Ensure that the ac power switch on the power supply
you are installing is in the Off position.
2. Install the power supply in the expansion unit.
a. Slide the power supply into the expansion unit.
Be sure the lever is pulled straight out as you
slide the power supply into the expansion unit.
b. Close the lever until the pull-ring latch locks in
place. Make sure the lever locks into place in
the expansion-unit chassis.
3. Wrap the clamp around the power cord approximately
20 cm (8 in.) from the power supply connection end.
4. Attach the power supply nut and tighten it securely.
5. Connect the power cord to the power supply.
Netfinity FAStT EXP500 - Type 3560
91
Summary of Contents for EXP15
