IBM eServer BladeCenter JS20 Type 8842, Installation And User Manual

Page: 85 / 150

Checkpoint code Description Suggested action
E1FB Reserved Have the blade server serviced.
E1FC Build the boot list for serial storage
architecture (SSA) adapters. The
location code of the SSA adapter
being scanned is also displayed.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E1FD E1FD and another progress code
(Exxx) will alternate in the operator
panel. The other code indicates
where the error occurred.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E1FE Build the boot list for Fibre Channel
adapters. The world-wide port
number (WWPN) of the SAN adapter
being scanned is also displayed.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E1FF Building the boot list for Fibre
Channel adapters. The WWPN of the
SAN adapter being scanned is also
displayed.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E199 Restarting (rebooting) the partition to
activate the changes that are
specified in the boot-image’s
executable and linkable format (ELF)
header.
1. Check the http://www.ibm.com/pc/support/ Web site
for a later firmware version that might address the
problem. For additional information, see “Updating
the firmware code for the blade server and the
service processor” on page 20.
2. If a later firmware version is not available, or if the
problem remains after you update the firmware
code, go to the “Boot problem resolution” section in
the BladeCenter JS20 Type 8842 Hardware
Maintenance Manual and Troubleshooting Guide .
Follow the instructions in that section.
E200 I
2
C bus controller initialization.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. If the problem remains, force the system to start
from the PERM flash image to reflash the TEMP
image for recovery. See “Recovering the system
firmware code” on page 95.
3. If the problem remains, replace the blade server.
Contact a service support representative for
assistance.
E201 The flash random-access memory
(RAM) cyclic redundancy check
(CRC) checksum is valid.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E202 Programmable interrupt controller
(MPIC) initialization.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Chapter 10. Solving problems
69