IBM eServer BladeCenter JS20 Type 8842, Installation And User Manual

Page: 52 / 150

IDE drive
Tray
Riser
card
Short screws
IDE connector 1
(J1)
IDE connector 2
(J2)
Attention:
v
Drives must be installed in the following order: IDE connector 1 (J1) first, then
IDE connector 2 (J2).
v Do not install a hard disk drive in IDE connector 2 if you intend to also install an
optional I/O expansion card. The I/O expansion card occupies the same area as
the second IDE hard disk drive.
v
Do not press on the top of the hard disk drive when installing it. Pressing the top
could damage the hard disk drive.
v
IDE hard disk drives must be set to master.
Complete the following steps to install a 2.5-inch IDE hard disk drive:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 31.
2. If the blade server is operating, shut down the operating system by typing the
shutdown -h now
command. If the blade server was not turned off, press the
power-control button (behind the blade-server control-panel door) to turn off
the blade server. See “Blade server controls and LEDs” on page 53 for more
information about the location of the power-control button.
3. Remove the blade server from the BladeCenter unit. (See “Removing the
blade server from the BladeCenter unit” on page 33 for instructions.) Carefully
place the blade server on a flat, static-protective surface.
4. Open the blade server cover. See “Opening the blade server cover” on page
34 for instructions.
5. Insert the riser card from the option kit into an IDE connector on the blade
server system board.
6. Place the tray from the option kit over the riser card as shown in the preceding
illustration, aligning the tray with the screws on the system board. Note the
four screws that are under the four screw holes in the tray. Set the tray aside
and remove the four screws.
7. Replace the tray and secure the tray to the system board with screws from the
hardware kit.
36
BladeCenter JS20 Type 8842: Installation and User’s Guide