IBM @server xSeries 343, Product Manual

Page: 108 / 193

96 Upgrading the Hardware
TP00486
B
A
Figure 30. Disengaging the Retention Clips from the Processor Socket
The Heat Sink Clip Attach/Removal Tool may be ordered/purchased from:
Dexter Design (United States)
(503) 648-7000
Contact: dxtrdsgn@aol.com
P/N: 650308-003-P6
4. Once the retention clips are free, lift the heat sink upward off the retention mechanism brackets.
5. Raise the locking bar on the socket. Refer to Figure 25.
6. Remove the old processor from the socket.
7. Aligning the pins of the replacement processor with the socket, insert the replacement processor
into the socket. Refer to Figure 26.
8. Lower the locking bar completely. Refer to Figure 27.
9. Follow the instructions packaged with your boxed processor for preparing the heat sink and
processor for installation.
10. Position the heat sink above the processor. Refer to Figure 28.
11. Aligning the raised metal surfaces, place the heat sink on top of the processor.
12. Place the heat sink clip so the tab on the clip engages the slot on the heat sink and the hole
opposite the tab slides over the stud on the mounting bracket (A). Refer to Figure 29.
13. When the clip is mounted in the slot on the heat sink and over the stud on the mounting bracket,
move the clip to the right as far as it will travel (towards C). Refer to Figure 29.