IBM Aptiva 2144, Hardware Maintenance Service

Page: 55 / 246

To disable Rapid Resume without changing the customer settings:
1. Make sure the customer saves and closes any open files.
2. Press Ctrl+Alt+Del while the words “Rapid Resume” appear at the
bottom of the screen following the POST icon screen.
3. When the system reboots, press F1 while the POST icon is displayed.
4. In the Setup Utility, select the Rapid Resume option from the main
menu.
5. Write down the present setting for the
APM BIOS Mode
(top line of
screen) and press the
↓
key to select
Disable
in the APM BIOS Mode
field.
6. Press Esc, select Yes, and press Enter to save the changes.
7. The Rapid Resume feature is now disabled.
When service is complete, restore the setting you wrote down in Step 5
(the original customer settings). The factory setting for the
APM BIOS Mode
field is 32-Bit Protected mode.
1. Power on the system unit.
2. Press F1 while the memory count is running.
3. In the Setup Utility, select the Rapid Resume option from the main
menu.
4. Press the
↑
key to select the previous customer setting (that you
wrote down in Step 5 in the APM BIOS Mode field.
5. Press Esc, select Yes, and press Enter to save the changes.
The system is now returned to the Rapid Resume customer settings.
– Go to Step 005.
003
Insert the Advanced Diagnostics diskette Service Level
I
in drive A.
DOES THE SYSTEM LOAD THE ADVANCED DIAGNOSTIC PROGRAM
FROM THE 3.5-IN. DISKETTE DRIVE (DRIVE A) WHEN POWERED OFF
AND THEN ON?
Yes No
004
– Go to “Factory-Installed Drive Devices” on page 2-38.
005
(From step 002)
(Step 005 continues)
Check Procedures
2-5