IBM 86594RY - Netfinity 5000 - 4RY, Hardware Maintenance Manual

Page: 77 / 220

3. Check the instructions that come with the drive if you
need to set any switches or jumpers on the drive, or if
you need to attach a tray to the drive.
What to do next
Ÿ
To install a removable-media drive, go to
“Installing or removing drives in bays A and B
(removable media).”
Ÿ
To install a diskette drive, go to “Installing or
removing a drive in bay C (diskette drive)” on
page 70.
Ÿ
To install a hard disk drive, go to “Installing or
removing drives in bays 1 through 5 (hard disk
drives)” on page 72.
Installing or removing drives in bays A and
B (removable media):
This section gives the
procedure for installing a removable-media drive. If you
want to remove a drive, reverse the following steps.
Before you begin
Ÿ
Read “Safety information” on page 176.
Ÿ
Read “Preinstallation steps (all bays)” on
page 67 and the instructions that come with the
option.
Ÿ
Read “Termination requirements” on page 67
1. If you have not done so already, remove the server
cover and the front bezel. See “Option installation”
on page 125.
2. Remove the bay cover plate, if present.
a. Remove the screws on either side of the cover
plate that secure the plate to the target bay.
b. Remove the cover plate from the server front
panel. (Save the cover plate for future use.)
3. Using the instructions that come with the drive,
together with these instructions, check that any
switches or jumpers on the drive are set correctly.
Change the settings if necessary. For information
about termination requirements, see “Termination
requirements” on page 67.
4. Position the drive with the connectors facing the rear
of the server.
Netfinity 5000 - Type 8659
69