IBM 86594RY - Netfinity 5000 - 4RY, Hardware Maintenance Manual

Page: 111 / 220

To prepare the Netfinity 5000 for installation in a rack
enclosure:
1. Attach the cable-arm bracket to the rear of the server.
a. Remove the two screws at the left of the primary
power supply.
b. Align the cable-arm bracket with the screw holes,
keeping the solid arm of the bracket toward the
side of the server. Make sure the openings in
the bracket align with the power supply LEDs
and the fan.
c. Attach the bracket with the two screws you
removed in step 1a.
2. Attach the inner slide section of each slide rail to the
side of the server.
a. Pull the inner slide until the safety latch locks.
b. Press the safety latch; then, pull the inner slide
firmly until it detaches from the outer slide rail.
c. Align the holes on the inner slide with the holes
on sides of the server; then, attach the slide with
three pan-head short screws (M4 by 5 mm).
Netfinity 5000 - Type 8659
103