Controller Module Exchange
Notes
1. In a 8265 with two installed Controller modules, removal of the active Controller module causes a
fast reset (the standby Controller module becomes the active Controller module). In a 8265 with
one installed controller module, removal of the controller module causes the switch to go down.
2. If you have a standby controller module installed, make sure the Standby LED (STBY) is ON
before attempting to remove the active Controller module.
To remove a Controller Module:
1
Loosen the screws at the top and bottom of the module faceplate until the screws disconnect from
the switch.
2
Grasp the end of the module ejector at the lower left corner of the faceplate, and pull it down. This
action causes the ejector to exert pressure on the switch, forcing the Controller Module out of the
slot so its faceplate can then be grasped.
3
Grasp the faceplate and pull the Controller module straight out of the slot.
Note: Each 8265 Controller module is equipped with an ejector that helps you to remove the
Controller module. This ejector can be in any position when you install the Controller module.
Slide the Controller
Module into the
selected slots as
shown here.
Figure
4-4. Installing a Controller Module
4
Lock the ejector into place by applying pressure to the Controller module faceplate with one hand as
you pull up on the end of the ejector. Ensure that the Controller module remains fully seated in the
backplane connector as you close the Controller module ejector.
5
Lift the end of the ejector until the ejector locks into place.
6
Complete the installation by hand-turning each of the spring-loaded screws at the top and bottom of
the module in a clockwise direction. Do not overtighten the screws.
4-8
8265 PD and SG
Summary of Contents for 8265 Nways ATM Switch
