IBM 4247 Model 003, User Manual

Page: 209 / 392

11. Close the front tractor cover.
E61A5034
12. Press Load/Eject to feed the forms.
13. Press Start to make the printer ready.
The printer is now ready for jobs that use the Front Push forms path. If your
applications do not control forms settings (such as Characters Per Inch, Lines Per
Inch, or Maximum Print Position [MPP]), and you do not want to use the printer
default settings, see Chapter 3, “Checking and Changing Configuration Parameter
Values”.
Rear Push Forms Path
Installing Forms Tractor in Rear Push Position
This illustration shows the Rear Push forms path from the left side of the printer.
Power Switch
Rear Push
Manual Sheet Feed
Paper Exit -
Rear Push and
Manual Sheet Feed
Note:
The forms path procedures always assume that a tractor not installed in the
printer is stored in the Push or fully-extended position. If you remove a
tractor from the Rear Pull or angled position, use the following procedure
before storing it:
v
Place the tractor face down on a flat surface with the electrical connector
tab on the right side, pointing toward you.
Chapter 17. Setting Up Forms Paths
199