IBM 220, Hardware Maintenance Manual

Page: 75 / 178

Installing options
67
The following illustration shows how to reroute the SCSI cable. If you install a
ServeRAID adapter and intend to use it with hot-swap, hard disk internal drives,
remove the cable from the internal SCSI connector (J41) on the system board and
connect it to the ServeRAID adapter.
Note: You can also install a ServeRAID adapter in non-hot-swap models;
however, non-hot-swap models do not support hot-swap hard disk drives.
13. If you have other options to install or remove, do so now; otherwise, replace the
support bracket assembly; then, go to “Installing the cover” on page 83.
Note:
If the server is a hot-swap model, reinstall the VRM in connector J42 after you
reinstall the support bracket assembly. (See “System board options
connectors” on page 55 for connector location.)
Installing internal drives
Different types of drives allow the system to read multiple types of media and store
more data. Several types of drives are available, such as:
• Diskette (preinstalled)
• Hard disk (preinstalled on some models)
• CD-ROM (preinstalled)
• Tape
Internal drive bays
Internal drives are installed in bays. The bays of the xSeries 220 are in the front of the
server, as shown in the following illustration.
ServeRAID
adapter
SCSI connector
(J41)
SCSI cable