IBM 220, Hardware Maintenance Manual

Page: 73 / 178

Installing options
65
2 supports the optional system management adapter. For additional information
on the optional system management adapter, refer to the documentation that
comes with the adapter.
Installing an adapter
Attention:
When you handle electrostatic discharge (ESD) sensitive devices, take
precautions to avoid damage from static electricity. For details on handling these
devices, see “Handling electrostatic discharge-sensitive devices” on page 136.
To install an adapter, do the following:
1. Review the safety precautions in “Safety information” on page 133.
2. Turn off the server and peripheral devices, and disconnect all external cables and
power cords; then, remove the side cover. See “Removing the side cover” on page
59 for details.
3. Carefully remove the support bracket assembly from the server (see “Removing
the support bracket assembly” on page 61). Store the cover and the support
bracket assembly in a safe place.
4. Determine which PCI slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements or
restrictions.
5. Remove the rear adapter retaining bracket from the server. If you are installing a
full-length adapter, rotate the front adapter support bracket to the open
(unlocked) position.
6. Remove the expansion-slot cover. Store it in a safe place for future use.
Rear adapter
retaining
bracket
Front adapter
support
bracket
Adapter
Expansion-slot
cover