IBM 220, Hardware Maintenance Manual

Page: 105 / 178

© Copyright IBM Corp. 2000
97
FRU information (service only)
Button kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 97
Hot-swap hard disk drive cage . . . . . . . . . . . . . . . . 98
Hot-swap backplane . . . . . . . . . . . . . . . . . . . . . . . . . 98
Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99
Rear fan. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100
System board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 101 CD-ROM drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . 102
Floppy disk drive . . . . . . . . . . . . . . . . . . . . . . . . . . 103
Bezel release latch. . . . . . . . . . . . . . . . . . . . . . . . . . 104
Top/side cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104
Handle assembly . . . . . . . . . . . . . . . . . . . . . . . . . . 105
Adapter retainer . . . . . . . . . . . . . . . . . . . . . . . . . . . 106
Field Replacement Units (FRUs) should be replaced by qualified service personnel
only.
Button kit
Before you begin:
• Read “Safety information” on page 133.
• Review the information in “Before you begin” on page 58.
To remove the button kit, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see “Removing the side cover” on page 59).
4. Remove the front bezel (see “Removing the bezel” on page 60).
5. Remove the hot-swap hard disk drive (see “Hot-swap hard disk drive cage”).