IBM 220, Hardware Maintenance Manual

Page: 67 / 178

Installing options
59
Rotating the stabilizing feet
The feet attached to the bottom cover rotate 90 degrees to provide additional stability
for the server.
Place the server in an upright position; then, rotate the feet a quarter turn away from
the server. Carefully position the server on its feet.
When you need to access the inside of the server to install options, you might find it
easier to place the server on its side, so that the system board is facing you. If you do
so, rotate the feet in towards the server, so that they do not break off due to the weight
of the server.
Removing the side cover
The following information describes how to remove the side cover.
Note: The illustrations in this document might differ slightly from your hardware.