i-CAT FLX V Series, User Manual

Page: 90 / 96

B-2
i-CAT FLX User Manual
032-0329-EN Rev K
Operational Messages
SmartScan STUDIO may display system message in a dialog box. These messages may be
informational only or may indicate the need to recover from an error. Follow instructions in the
message dialog box. If problems persist after performing the indicated actions, call Technical
Support.
Message Action Possible Cause
The Emergency Stop button was
activated.
Press OK once the E-Stop button
is reset and Patient Environment
is ready to be reset.
E-Stop button pressed.
The machine is turned off. Turn scanner on. Scanner powered off.
The system has timed out. Retry scan.
Scan button not pressed within
two minutes after scanner
initialization.
Images were successfully saved. Information only.
Raw data was captured and
saved.
Image processing was canceled
by user.
Information only. If image
processing is desired, use
Reprocess Exam.
User canceled image
processing.
A scanner stall was detected.
Press OK once the Patient
Environment is ready to be reset.
Scanner stall.
Images were successfully saved.
Images can be reprocessed
using the Reprocess Exam
Feature.
If image processing is desired,
use Reprocess Exam.
User canceled image
processing after successful
scan.
X-ray exposure aborted due to
door opening or early release of
X-ray switch. Press Reset Scanner on dialog
box. When scanner is reset,
initiate re-scan of the patient. Door was opened or deadman
handswitch was released
during the exposure.
The scanner Ethernet cable was
disconnected during scan.
If possible, reconnect Ethernet
cable at back of scanner
controller and back of scanner.
Initiate scan when operational.
Scanner Ethernet cable was
disconnected.