60
Chapter
Chapter
Chapter
Chapter4
4
4
4.
.
.
. Inverter Operation
Inverter Operation
Inverter Operation
Inverter Operation
N5000 INSTRUCTION MAN
N5000 INSTRUCTION MAN
N5000 INSTRUCTION MAN
N5000 INSTRUCTION MANUAL
UAL
UAL
UAL
4.3.19 Group C Screen 4
‘Group C Screen 4’ screen panel comes out when DOWN (
) button in ‘Group C Screen 3’ screen
panel or UP (
) button in ‘Group C Screen 5’ screen panel is touched. Availabilities, output
frequencies, output currents, and output voltages of all 4 analog output terminals of N5000
inverter can be monitored or set in this screen panel. Each output terminal can have output
voltage form 0V to 10V by configuring gain and output type.
Figure 26 Group C screen 4
When touching any button in the sreen panel, 10KEY screen comes out for inputting values. (refer
to [Input way of 10KEY screen]).
(1)
DA 1~4: Analog output terminals. The functions that are allocated to the numbers are as
follows.
0: [Displays ‘No Used’] No function. Terminal is not used.
1: [Displays ‘Ref. F’] generates voltage (0~10V) to show commanding frequency.
0V: commanding frequency is 0[Hz].
10V: commanding frequency is the same as maximum frequency (set in group A
screen 1). (In case of ‘DAx gain’ value of the channel is 1).
2: [Displays ‘Out F’] generates voltage (0~10V) to show inverter output frequency.
0V: output frequency is 0[Hz].
10V: output frequency is the same as maximum frequency (set in group A screen
1). (In case of ‘DAx gain’ value of the channel is ‘1’).
3: [Displays ‘Out RPM’] generates voltage (0~10V) to show the speed of the motor. The
speed of the motor is measured using speed sensor.
0V: motor speed is 0[RPM].
10V: motor speed is the same as the maximum speed of the motor. (In case of
‘DAx gain’ value of the channel is ‘1’).
