Hyster H40-60XT, Operating Manual

Page: 73 / 180

2. Move forward slowly until the forks are in position under
the load. The forks must support at least two-thirds (2/3) of
the length of the load.
Make sure that the load is centered between the forks.
Make sure that the forks do not extend past the load so that
loads or equipment that are behind the load being lifted are
not damaged. Lift the load a small distance from the floor to
make sure the lift truck has the capacity to lift the load.
A. BE CAREFUL OF FORKS BEYOND THE LOAD
If the forks are longer than the load, move the forks under
the load so that the tips of the forks do not extend beyond
the load. Lift the load from the surface. Move backward a
few inches, then lower the load onto the surface and inch
forward to engage the load against the carriage. Tilt the
mast backward just far enough to lift the load from the sur-
face.
3. When a load is put on the floor, tilt the mast forward to a
vertical position and lower the load. Tilt the mast forward to
permit smooth removal of the forks. Carefully move the lift
truck backward to remove the forks from under the load.
Operating Procedures
71