Hyster H40-60XT, Operating Manual

Page: 156 / 180

WARNING
DO NOT lubricate the tire bead with antifreeze or petro-
leum-based liquid. Vapors from these liquids can
cause an explosion during inflation or use.
5. Make sure the rim is the correct size for the tire. Lubri-
cate the part of the wheel that contacts the bead and flap.
6. Install the three-piece or four-piece wheel in the tire as
shown in Tire Installation Three- or Four-Piece Wheel .
7. Install the two-piece wheel in the tire as shown in Tire
Installation Two-Piece Wheel .
Tire Installation Three- or Four-Piece Wheel
WARNING
Damage to the tire and wheel assembly and injury or
death can occur if you do not do the following proce-
dures:
• Clean and inspect all parts of the wheel before
installing the tire.
• DO NOT use any damage or repaired wheel parts.
• Make sure that all parts of the wheel are the correct
parts for that wheel assembly.
• DO NOT mix parts between different types or manu-
facturers of wheels.
• DO NOT mix types of tires, type of tire tread, or
wheel assemblies of different manufacturers on any
one lift truck.
DO NOT use a steel hammer on the wheel. Use a rub-
ber, lead, plastic, or brass hammer to put parts
together. Make sure that the side ring is in the correct
position. The ends of the side ring must not touch. The
clearance at the ends of the side ring will be approxi-
mately 13 to 25 mm (0.5 to 1.0 in.) after it is installed. If
the clearance is wrong, the wrong part has been used.
1. Install the inner tube and the rubber flap
in the tire.
Maintenance
154