Hyster H40-60XT, Operating Manual

Page: 140 / 180

Legend for Figure 31
NOTE: HOOD REMOVED FOR CLARITY.
1. BATTERY
2. POWER DISTRIBUTION MODULE (PDM)
3. START RELAY
4. STARTER (30 AMP)
5. RESISTOR (68 OHM)
6. IGNITION 3 RELAY
7. TRANZORB
8. IGNITION 1 RELAY
9. REAR WORK LIGHT RELAY
10. BATTERY (25 AMP)
11. IGNITION 1+ (20 AMP)
12. REAR WORK LIGHT (20 AMP)
13. FRONT WORK LIGHT RELAY
14. BACKUP RELAY
15. (25 AMP)
16. FRONT WORK LIGHT (20 AMP)
17. (20 AMP)
18. BACKUP (20 AMP)
19. IGNITION 3+ (30 AMP)
20. FUEL/RUN (20 AMP)
21. FUEL/RUN RELAY
Service Brakes
Brake Fluid Level
WARNING
If the brake system has a power assist (or boost), brak-
ing will be more difficult if the engine is not running.
Loss of fluid from the brake fluid reservoir indicates a
leak. Repair the brake system before using the lift
truck. Replace the brake fluid in the system if there is
dirt, water, or oil in the system.
Operation, Check
Check the operation of the service brakes. Push on the
inching/brake pedal. The service brakes must be applied
before the inching/brake pedal reaches the floor plate. The
pedal must stop firmly and must not move slowly down
after the brakes are applied. The service brakes must apply
equally to both drive wheels. The service brakes must not
pull the lift truck to either side of the direction of travel when
they are applied. The service brakes are automatically
adjusted when the transmission is in reverse and the lift
Maintenance
138