Hypercable Compack, Booklet

Page: 27 / 68

27
How To Change the Compack Controller’s Device Name
In order to facilitate identification of the Compack -based power system when connected a LAN, it is advisable to log in with the “admin” account and give the Compack
controller a Device name of your choice. For acronym descriptions, refer to chapter “Glossary”, page 44 .
Carry out the following steps to give a Device name to the controller, using the Compack controller’s configuration pages in your Web browser:
Now the Eltek Valere Network Utility window will display the new device name.
1. Access the controller’s configuration pages
in your Web browser
by opening your Web
browser (e.g. Internet Explorer) and entering
the controller’s IP address in the browser’s
address line. (E.g. <169.254.52.133>; entering
“http://” before the address is not necessary)
2. Log in with the <admin> account, by
clicking on the “Enter” link — in the Web
browser, in the middle of the page — and
entering <admin> as user name and <admin>
as password (case sensitive) (unless you have
previously changed it). Note that the Web
browser must have the Pop-ups function
enabled, as the configuration web pages
employs Java script navigation. Read chapter
“How To Enable Pop-ups in the browser —
Internet Explorer”, page
24 .
3. Change the controller’s Device Name by,
— Clicking on “Network Config” button, in the
Power Explorer’s toolbar — Clicking on the
“TCP/IP” tab — Clicking in the Device Name
field and entering the Device Name that
describes your power system, e.g. “Micropack
System, EV Engine Room, Oslo” — Then
clicking on the “Save” button, to active the
controller’s new device name